I often create models with multiple support conditions. Because of STAAD's requirements on support degrees of freedom I have to model lift cases first. This means that I cannot model seismic cases first as required if I want to use STAAD's seismic...

Currently, according to Bentley Support, the Material Definition properties are only used in the Connection Design module and are not used for steel design & code checking. The SGR, FYLD, FU parameters must be used instead to define the materi...

May you please include the design of waffle slab, ribbed slab and flat slab in rcdc

Please allow user to remove multilinear springs in GUI rather than going into the editor to remove 1 or 2 lines of text.

currently if anyone need to add the beams in group definition, all the beams including existing added need to be selected. if new beams can be added without selecting existing beams, it will be easier

Please consider adding an autosave feature. A real autosave not a prompt that appears every so often minutes asking you to save. One that will autosave without input. Autosave is pretty much a standard now across a variety of softwares, so constan...

We request to at the OpenSTAAD function to renumber Nodes just like we do with beams.

Within the Annotation Menu, could you include Plates Stresses & Nodal Forces ? This will be very useful to display specific plate /nodal results during compilation of Structural reports. Given that the contours only show a range of values. Thi...

These could be used when performing member or shell design in STAAD.Pro, as well as Advanced Concrete design. See applicable snapshots attached. User would like to be able to do design to NZ codes in STAAD.Pro (specifically concrete and timber,...

It should work similarly to code checking steel members according to EN 1993-1-1. It would benefit everyone designing aluminum structures due to highly corrosive environments and/or weight restrictions.