All features of ADINA should be implemented and available in staad pro also. Like, Non-linear dynamics analysis, hydrodynamic (impulsive & compulsive sloshing load), Computational fluid dynamics, Potential fluid dynamics, Modelled of water in ...

This will reduce the tedious process of turning on and off each design parameter from editor file and then running the full input file again multiple times. If this can be implemented for AISC-360 then it shall be implemented for other codes also.

Hi, I have an OpenSTAAD program that generates groups and that applies loads to the elements/beams/nodes in those groups. However I'd like to apply the load to the group directly using openSTAAD as you can in the STAAD Command File? What I want to...

The new report formatting while nice in appearance is cumbersome, not quick to use and has issues with savings....can't there be an ability for staad users to "revert" back to the old school report formatting?

I chose this "add idea" route because I couldn't find another channel to communicate my disappointment as stated below. Report setup in STAAD. Pro 2024 is not good. It gives poor quality picture compared to previous versions. This kind of weird pr...

currently, only 2 decimal numbers are displayed for plate thickness. when there are different plate thickness are input, and the thickness differences is on the 3rd decimal number, it will be hard to figure out which one is which, since they are d...

In Staad, is there any way to reduce the size of pin symbol and beam orientation symbol? Like support symbols. Thanks

for site engineer ,it is useful to understand calculation report.as input parameters added in the calculation report, it is benefit for checker to review. eg. beam section ,column section ,steel strengh ect.

Staad pro should have an option to model each and every type of staircase like single flight (straight)stairs,dog ledged strair, spiral stair, U shape stairs,L shape stairs,winder, double winder, 2 quarter winder, 2 quarter landing,curved staircas...

Till now, staad pro has an option to assign plates of various thickness, but it should also have an option to model such plates in TRAPEZOIDAL PATTERN as shown in below images,which is frequently used to model raft foundation, also placement and b...