It would be helpful if the Shrink command under Structure Diagram would only shrink the members with released ends. This would make the diagrams look more like a design drawing and would make it easier to check that you have released the right mem...

Requesting to add NSCP 2022 Philippines Seismic Load(similar to ASCE 7-10) addition to STAAD.Pro. Xstructures can provide all formula and technical documentation

There is currently no way, other than directly adding rigid body members with the necessary releases, to simulate an an axial angle or tee member (brace) under eccentric axial load. This causes a high amount of manual calculations to determine the...

Serviceability check doesn't work when using sections from Mexican Tables or prismatic sections producing the error: "To use this tool the model should have section profiles and materials assigned to all members." When I change all my sections to ...

We propose the Joist Design member, because there is a way to use a joist Sji member but it doesnt desgin it, also considring bridging

Sometimes these drawings are sent to other colleagues that do 3D modeling, and sometimes do not know that W200x27 TEE === WT100x13. It would be an improvement for the Schedule of Sections and MTOs show the correct WT callout, when a STAAD users sp...

Please allow option to save drawings from AutoDrafter to PDF.

There is currently no way to create a base plate plan in AutoDrafter. Please add it.

Could you please make the 'result utilization ratio' field directly editable? Currently, it's set to a default of 1, but we need to set values like 0.9 or 0.95. While it's possible to adjust this using a detailed diagram, the values changes with e...