Base pressure contour for raft footing is available for the envelop of the loads in Space Gass but not in STAAD. It is important to have this feature be implemented in STAAD too to facilitate the raft footing design based on allowable bearing pres...

Can we have a single query where we can have both the Bending Moments, and Shear forces can be sketched in the query report? adding the Deflection Diagram would also be an added advantage.

When there are many types of load definitions, it is difficult to distinguish which one each load is. If you can customize the name, it will be easier to distinguish and verify

Anyone who perform post-processing/detailed analysis on plated structures will benefit from this. The function could take a plate ID and loadcase as input, and give plate corner stresses for all corners as output.

I chose this "add idea" route because I couldn't find another channel to communicate my disappointment as stated below. Report setup in STAAD. Pro 2024 is not good. It gives poor quality picture compared to previous versions. This kind of weird pr...

for site engineer ,it is useful to understand calculation report.as input parameters added in the calculation report, it is benefit for checker to review. eg. beam section ,column section ,steel strengh ect.

easy way to find the section properties . Also all the flange width and thickness and web depth is coming except web thickness

In spite of selecting Metric units for member section properties at the beginning of a new model (considering Indian codes), while checking the member sections during modelling and analysis, the member properties are getting displayed in FPS units...

Till now, staad pro has an option to assign plates of various thickness, but it should also have an option to model such plates in TRAPEZOIDAL PATTERN as shown in below images,which is frequently used to model raft foundation, also placement and b...