Design of cantilever slab in RCDC should be added and also slab supported by beams on its two sides and its other two sides free or only three sides are supported by beams and the other side free.
RCDC - Allow for rebar designs for sections with failures to investigate existing conditions.
When completing a design in RCDC if the member fails, you cannot edit the rebar. I would like to be able to edit reinforcement. Then after the reinforcement is added, I would like it to print a full report so I can see what is failing. This is so ...
hi
When you importing portal frame building in to RCDC for design concrete footing,display column is missing in RCDC,becuase columns are steel,make RCDC read for design footing
thanks in advance
Improvement to the Quality of Staad Advance Foundation detail Drawings
I am recommending that the same software engineers that is responsible for producing the detail drawings for RCDC should be responsible for producing the drawings for Staad Advance Foundation Design. The Detailing drawing designs in Staad Advanced...
Imperial system of construction (Feet Inches) is still very much in use at remote locations in india. Beams, slabs etc allow input of mm in decimal range for equivalent "in" cross section, such functionality is unavailable in coumns and I have to ...
I would like a new feature to be implemented in RCDC, when generating footing drawings , starter bar for the columns should be included in every footing detail as shown in the attached picture
0
Needs review