Automation of solidity ratio of steel structure for calculating wing load shall be done. It is very time-consuming process for every structure design.

WHILE CREATING A LATTICE FRAME WE NEED TO OPT FOR TWO ANGLES APART FRONT TO FRONT, BUT AS OFF NOW STAAD ONLY PROVIDES DOUBLE ANGLE WITH BACK TO BACK CONFIGURATION AND NOT FRONT TO FRONT, THUS IT IS REQUESTED TO ADD UP DOUBLE ANGLE SECTION WITH FRO...

Currently, the reports from STAAD Connection Design are stored in .doc format which is outdated. Please update this to the current format supported by word.

From 22years using Staad Pro, I propose to update the way to applied a load on beams as It's possible for nodes. In the case of nodes, We can do like this in one line: Joint Load 10 FX 10 FY -22 FZ 33 I propose You to update the syntax of applying...

It will be better is auto load combination for following IS codes, IS 802 Part 1/Sec1 2015 - Clause 13 - For Transmission tower Design IS 802 Part 4 2023 - Clause 13 - For latticed switchyard structure Design As of now only design code of IS 802 i...

in standard section data base only 90Deg hat is available, we are mostly using 75Deg hat

Sometimes, a member requires the assignment of a Beta Angle for a particular member, but after some iterations, it might not be needed. In the Beta Angle assignment tab, when someone defines a Beta Angle, it exists—but Beta Angle 0 is removed. In ...

Under Properties in Analytical Modeling, one can currently only highlight assigned geometry for a single section at a time. A button could be added to the table that allows you to show all section properties in the current view by color, and then ...

It is new code introduced by IS Commitee for Steel Design. Those engineers working on STEEL Design across any industry will have to use all codal provisions suggested by IS8168. Accordingly STAAD Pro has to be upgraded.

Dear Sir / Madam, Steel Auto Drafter is not giving beam presentation as per Releases provide in Analytical Modelling. Please check attached screenshot for your ready reference. Steel AutoDrafter drawings should be as per Release and Analytical mod...