Spring supports are created only in a particular direction. For e.g. base/soil springs. negative displacement is considered as compression. what if a steel base plate is to be modelled below a concrete slab. There is no way to create a compression...

All tapered section name shows as a tapered . its very useful if staad pro show the tapered section show the section in the display- Tapered I- 300x6+200x8+150x8 if its uniform web depth Tapered I- (300-750)x6+200x8+150x8 if its tapered web depth ...

It would be good to have a 3D view in post processing with colours of the beam as defined with a UR value. It is possible to have this with beam view now, but would be good if we have it for 3D view like SACS have. (as shown below for example).

Requesting to add NSCP 2022 Philippines Seismic Load(similar to ASCE 7-10) addition to STAAD.Pro. Xstructures can provide all formula and technical documentation

I consider that the way of using openstaad with VBA is somewhat tedious due to the characteristics of that programming language, therefore, my idea is to propose an openstaad repository but focused on python, which, in my opinion, would facilitate...

It is highly inefficient to require the user to switch cursors for each selection in STAAD. STAAD shall identify the context of operation automatically, and select the object required. Users should be able to select nodes, beams, plates, loads, te...

Connection Design Part in Staad.Pro now only support AISC 341-05, but as we know the latest edition of AISC 341 is AISC 341-16/22 .Althouth the ram connection can support AISC 341-16/22, but it need the designer to add every load case datas to the...

In STAAD 2023, if a report is created and the Utilization Ratio table is included, a critical Clause is listed for each member. However, there is no indication in/above the table of which code, or code version, that the Clause pertains to. Please ...

STAAD.Pro has offered aluminum design and ASD code checking for many years based on the 1994 Aluminum Design Manual. Since that publication was issued 26 years ago, there have been five subsequent versions released in 2000, 2005, 2010, 2015, and 2...

Hi I have an exceedingly large model which takes hours to run on RCDC. Also, when the model is exported from STAAD to RCDC, all the beam support points are not detected properly by RCDC and I have to spend days just correcting the Beam Continuum. ...