Spring supports are created only in a particular direction. For e.g. base/soil springs. negative displacement is considered as compression. what if a steel base plate is to be modelled below a concrete slab. There is no way to create a compression...

All tapered section name shows as a tapered . its very useful if staad pro show the tapered section show the section in the display- Tapered I- 300x6+200x8+150x8 if its uniform web depth Tapered I- (300-750)x6+200x8+150x8 if its tapered web depth ...

It would be good to have a 3D view in post processing with colours of the beam as defined with a UR value. It is possible to have this with beam view now, but would be good if we have it for 3D view like SACS have. (as shown below for example).

It is highly inefficient to require the user to switch cursors for each selection in STAAD. STAAD shall identify the context of operation automatically, and select the object required. Users should be able to select nodes, beams, plates, loads, te...

Hi I have an exceedingly large model which takes hours to run on RCDC. Also, when the model is exported from STAAD to RCDC, all the beam support points are not detected properly by RCDC and I have to spend days just correcting the Beam Continuum. ...

The accidental eccentricity in staad pro. as per Eurocode 1998:2004, while analyzing the structure for seismic loads using response spectra method.

Need a function similar to Midas automatic coupling plate element boundary

Pipelink is quite rudimentary. It does not provide the ability to assign guide supports to different nodes. For example, horizontal loads need to be applied to Vertical Members, while vertical loads need to be applied to Horizontal Members. The sa...

The STAAD.Pro now can not check the the vertical structural irregularities 5a/5b in the ASCE 7 table 12.3-2 by ant command stream, but as the code demand, the designer need check this irregularities, it is very difficult and cost time for designer...

Please provide report data in txt format for export in versions after 2023, as we need to maintain consistency with previous versions