Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

My ideas

Showing 171

It is hoped that the number of decimal places for the section thickness display can be increased to three, or the display unit of the section can be controlled.

No description provided
6 months ago in STAAD.Pro 1 Needs review

WIND CORNER PRESSURE AND ROOF IN WIND LOAD GENERATOR

Hello i would like to drop my suggestion for consideration, as we know up to now Wind Load generator, can only generate wind on panels. But during design we may have to apply corner wind pressure especially in connection design and also to apply w...
over 2 years ago in STAAD.Pro 2 Needs review

Calculator from the Input Editor / Command File

I wouldn't lie by saying that I'm a vivid user of the calculator from the withing the Input Editor/Command file. But at times when the Window's calculator crashes, Staad's calculator comes to the rescue. hoping to add a few suggestions: 1. rather ...
6 months ago in STAAD.Pro 1 Needs review

RCDC design all type of slab(waffle,rib,flat,solid)

No description provided
over 3 years ago in STAAD Concrete 1 Needs review

Request Omitted Data from IBC/ASCE7 Seismic Load Generator

There is no method, report, or output command available to display the "k" coefficient used by the program for vertical distribution of seismic base shear per ASCE 7-16, Eq 12.8-2. Since this value can vary with the period it needs to be reported ...
6 months ago in STAAD.Pro 1 Needs review

ADD the slenderness ratio to the normalized ratio

If the slenderness ratio meets the requirements, but its normalized ratio is not shown in the utilization table, can the slenderness ratio be added to the utilization table, which will help the designer to understand the condition of the member.
12 months ago in STAAD.Pro 1 Needs review

mass Load generator in Physical Modeller

It would be useful if Mass Model generator is included in physical Modeller.
about 1 year ago in STAAD.Pro 1 Needs review

water tank design with ACI code

the software need to design water tank with ACI code in RCDC,so we hope to add Aci code to it.
over 2 years ago in STAAD Concrete 2 Needs review

automated loading for intz tank

automated tool for hydrostatic loading should be included
about 1 year ago in STAAD.Pro 1 Needs review

Incorporate ACI-350 into RCDC

HDR designs many concrete water tanks (round and square). We use STAAD to generate a FEM mesh and then use the stresses to design the concrete elements with load factors unique to ACI-350.
over 1 year ago in STAAD Concrete 4 Needs review