Good morning Srs. I would like to control tolerance ratio Steel- utilization ratio.

Because you must create multiple wind definitions for wind along a single direction (i.e. windward, leeward, sidewall) it would be helpful to have the ability to combine these in a single load case. Combining them in the load combos is cumbersome....

There is the command NSF that modifies the net area of the whole member, but there isn't a command to modify the net area of the tension flange only to apply it to section F13 in AISC.

In the current AIJ2005 code allowable stress calculation of STAAD.Pro, the Young's modulus is fixed at 205000 (N/mm2). On the other hand, in the AIJ2002 code, by using the YNG=1 parameter, the Young's modulus used in the frame analysis can be use...

The Nuclear Code AISC N690 has not been updated since the 1994 edtion. It is not available for the recent nuclear power plant project, I bought a Nuclear Code, but it is useless because it has not been updated.so please update it.

Currently OpenSTAAD provides OpenSTAADUI:AnalyzeEx() which upon completion of the analysis returns an integer indicating the status analysis. However, it will be helpful if there is a function which provides more information about the Errors and W...

StaadPro provides the option to create a custom open section by defining a profile polygon (refer to the snapshot attached). Sections created this can be visualized as 3D objects when rendered instead of just showing a simple line. This helps in c...

Kindly add open staad function to remove selected member loads. Thank you.

Currently after run analysis we can see the status of design in postprocessing. If fail design appear, now we have to edit and rerun all model and check if edition is good or not. When only 5~10% of members fails, and in large models, this is very...