When members are merged any design parameters they have are lost. If members that have the same design parameters are merged, the newly created member should retain those parameters. Also, if the members had code checks done on them before the mer...

When designing concrete or masonry walls and slabs the rebar typically runs in two orthogonal directions. Because of this we are typically interested in stress results resolved to the slab or wall's local coordinate system. STAAD's analytical mode...

I think that the numbering on Load Group, Primary Load Case and Load combination spreadsheet should be customizable. This is very important when dealing with several design parameter and/or analysis load groups.

Currently saved report setups are only available to the model it was saved in. The user should have the ability to load a report template that he created that can be used for any job.

In the Loads window when you pick an existing load it highlights that load clearly. However, if you then click into the model window, say, to assign a member to that load, it changes it to a very light grey background. If you are going down the li...

The way like STAAD physical has it now allows to create only one by one panels with pressure redistribution only in x or Z direction. Just inclined members in the attached sketch cannot be loaded with parallel or perpendicular directions. Also it ...

May you add an option for choosing the strength stirrups in RCDC,by default is 250 but when i want to use stirrup of 410 its not possible to change its strength in RCDC

The Plate Center Stress table has Global Moments as one of the tabs. However there is no Summary tab corresponding to Global Moments that can enable the user to find out the maximum quickly.

Often when clicking on a different tab, say going from "Geometry" to "Properties" for example, STAAD will change the view in the graphics window. Please, please, please do not change the view when switching between tabs.

Please add HSS8x8x5/8 to the pull-down list in under Select Profile > ASTM > HSS - Square in Section Wizard.