Spring supports are created only in a particular direction. For e.g. base/soil springs. negative displacement is considered as compression. what if a steel base plate is to be modelled below a concrete slab. There is no way to create a compression...

Add tapered rectangular tube section  Extend the current tapered tube definition to allow for the specification and analysis of tapered rectangular tube profiles (i..e where the length of the two side dimensions differs). Currently STAAD.Pro ...

There should be a way to convert STAAD model to 3D pdf. It will become easy for designers to hover over the model and get clear view of the geometry while modelling in 3D softwares. Inspite of inputs provided, they will have access to 3D pdf where...

Can we have a single query where we can have both the Bending Moments, and Shear forces can be sketched in the query report? adding the Deflection Diagram would also be an added advantage.

All professional, practicing engineers would benefitted. One click analysis and one click reinforcements design of any types of tank UG/elevated of any shapes like RCDC.

Base pressure contour for raft footing is available for the envelop of the loads in Space Gass but not in STAAD. It is important to have this feature be implemented in STAAD too to facilitate the raft footing design based on allowable bearing pres...

Staad pro doesn't support for modelling of rigid diaphragm for inclined floor/inclined slab/inclined roof, so that response spectrum analysis can not be achieved in this case, so it is necessary to implement feature of modelling rigid diaphragm/se...

it is a very useful option when you are trying to hide some selected entity for better view. HIDE SELECTED OBJECT rather than using invert Selection and other ways.

I chose this "add idea" route because I couldn't find another channel to communicate my disappointment as stated below. Report setup in STAAD. Pro 2024 is not good. It gives poor quality picture compared to previous versions. This kind of weird pr...

When there are many types of load definitions, it is difficult to distinguish which one each load is. If you can customize the name, it will be easier to distinguish and verify