As of now, STAAD. Pro supports the older version of IS 802, specifically IS 802:1995, for the design of steel structures such as gantry structures and equipment support structures The updated version, IS 802:2023, which includes revised load facto...

We propose the Joist Design member, because there is a way to use a joist Sji member but it doesnt desgin it, also considring bridging

If i create any member using "Shape Editor" using built up members (Stadd pro version 24.00.02.354), then during "3d rendering" it shows only line diagram. Although this problem is continuing from the earlier version also. Is ther any solutions of...

Currently, accidental torsion analysis is only supported when using the Standard response spectrum excluding Eurocode, which needs to be specified. The functionality is not available for Custom spectra, which is a critical limitation that needs to...

Requesting to add NSCP 2022 Philippines Seismic Load(similar to ASCE 7-10) addition to STAAD.Pro. Xstructures can provide all formula and technical documentation

As the use of cold form sections becomes more prevalent, it's essential for STAAD to support C and Z shapes more comprehensively. These sections vary significantly across manufacturers and are not always available in the STAAD database. Furthermor...

There is currently no way, other than directly adding rigid body members with the necessary releases, to simulate an an axial angle or tee member (brace) under eccentric axial load. This causes a high amount of manual calculations to determine the...

Is there a function to carry out the Circular Repeat (similar to DoTranslationalRepeat)?. If not, is it possible to introduce this function?

At present we can define, generate mesh and commit the mesh using the parametric surface functions exposed by OpenSTAAD. However, many times passing the meshing parameters programmatically such as Meshing Type, Boundary Connectivity is important t...