STAAD does not have NZS 1170.5 in its Seismic Codes. Users in ANZ uses custom spectrum and factored it up to match the base shear. Adding this code will help the users in ANZ work directly with the NZ code and thus speed up their productivity. Use...

Currently, the only way to use STAAD.pro fireproofing specification is thru the Analytical Modeler. If you have a physical model, you have to break the connection and then edit the Input file to remove the "DO NOT EDIT" restrictions so that you ca...

I believe there is no option or command to directly view RC members that have failed, similar to that of "Utility" option available for checking failure of steel members. Failure of RC members must be manually checked from the "Analysis Output" op...

Please add the ability to automatically generate wind loading to eurocodes.

Heavy loaded structures...

Hi, Typically, to get end forces to design the connection for a certain beam size, a group is created and the bounding beam forces for the group are extracted using the "Beam Results - Beam Forces - Summary table" using the "Results Setup - Range ...

When dealing with a substantial number of members within a STAAD model, the design parameters tend to split automatically. Consequently, this automatic splitting poses challenges when attempting to review the design parameters. The same situation ...

The STAAD.Pro now can not check the the vertical structural irregularities 5a/5b in the ASCE 7 table 12.3-2 by ant command stream, but as the code demand, the designer need check this irregularities, it is very difficult and cost time for designer...