dear teams,please make corrects for software when you design water tank with slab including beams,RCDC not reading beams,plz correct it,thanks in advance
over 2 years ago
in STAAD.Pro
1
Will not implement
Better integration of physical members in Analysis Model
When a physical member is created, STAAD should handle the collection of beams as one entity. When a section of material is assigned, it should always be to the physical member. End releases will only exist at the ends of the physical member. Curr...
The possibility to presents diagrams with annotation is very importent for the documentation of analysis. Today the annotation of values for forces, moments, dispacements and so on does often clash with the geometry plot. The possibilites to adjus...
Enable view of in-plane bending moment for each wall plate in masonry & concrete shear walls.
Currently I need to cut a line or plane at the base of a masonry shear wall in order to determine the in-plane bending moment. However, that effort produces the total moment for the entire cut. It would be more convenient if I could just click on ...
addition of new beams in existing group definition
currently if anyone need to add the beams in group definition, all the beams including existing added need to be selected. if new beams can be added without selecting existing beams, it will be easier
over 1 year ago
in STAAD.Pro
1
Future consideration
In load data page when you select any specific UDL or point load, then the UDL or point load associated beam and node shall be auto selected or highlighted. this will help to identify if load applied is at right location or not
Company Logo needs to be changed for every project, that is a tedious practice.
While generating Report, Company Logo needs to be changed for every project, that is a tedious practice. The changes should be permanent and for company.
Within the Annotation Menu, could you include Plates Stresses & Nodal Forces ? This will be very useful to display specific plate /nodal results during compilation of Structural reports. Given that the contours only show a range of values. Thi...
over 1 year ago
in STAAD.Pro
2
Future consideration
This might be difficult to implement, but it might be nice if you could label the node numbers in the physical modeler different than used in the analytical modeler so that you could keep those nodes the same. Therefore, they would show up the sam...