Wind loading generator would be very attractive and fast to use, if it would generate uniform loading on column members instead of point loads for column nodes. I watched a session where in my understanding, wind load generator applies uniform loa...

Beam force summary table is available at node locations only. How about adding summary table at midpoints of beam

Connection Design模块中的AISC 341只能支持到05版规范吗，这个什么时候可以更新支持到16及22版规范，虽然ram connection可以支持到AISC 341 16及22版规范，但这需要设计人把每个节点的各个工况的内力提取出来，太耗精力了，实 现起来太国难

I wish Bentley add an auto load combination here in Philippines that based on NSCP(National Structural Code of the Philippines)-2015 so that it lessens the workflow.

implement Indian Aluminum design code in STAAD Pro

STAAD is not able to design the I-SECTION with TB(i.e. Top and bottom cover plates) in Eurocode. Code used :- CODE EN 1993-1-1:2005 SECTION USED :- UB1016X305X487 TB This warning is shown in the output file as below.***STAAD.Pro WARNING***MEMBER 1...

These codes would be used when performing member design for timber members See applicable snapshots attached. User would like to be able to do design to NZ codes in STAAD.Pro.

Dear Colleagues, Say, I have STAAD file with 30K+ plates & 3K+ beams. which might take app.30+ minutes to run/check the Plate and/or Beam+Plate connectivity checks. When rectifying as per the listed beam/plates irregularities if 'by accident' ...