I would like to suggest the addition of column designs that are inclined at an angle. You may find a project having many columns inclined at a certain angle; it will consume a lot of time to design them manually, as RCDC is not capable of designin...

Hello i would suggest STAAD and RCDC to implement design of beams which are inclined at angle to meet project requirements.

This issue exists in all design codes.beams without grouping, edit reinforcement works properly. if beams are grouped, software unable to change the reinforcement.for grouped beams, quick detail and copy paste reinforcement works fine. Service cas...

refer Service case Service Case 1494311: [CS0270621] Combined wall design taking more timeAs alternate solution is available, it is marked as Low severity.

This issue exists in all design codes.beams without grouping, edit reinforcement works properly. if beams are grouped, software unable to change the reinforcement.for grouped beams, quick detail and copy paste reinforcement works fine. Service cas...

following issues are identified, program goes on non-responding mode using Quick detail tool. reinforcement changed using copy paste reinforcement tool is not reflected in the design calculation report. client file is of older version (11.03.01.10...

refer Service case Service Case 1441906: [CS0222209] Calculation basis for buoyancy and sliding check of pad footingsif the soil and self -weight is calculated with effect of buoyancy then there is no need to deduct it again to calculate net downw...

refer service case - Service Case 1361907: RCDC software will be collapsed if the model contain an earthquake load combination.if higher diameter is not available and ductile detailing is not satisfied with the available diameter (with minimum spa...

please refer to service case: Service Case 1365610 : [CS0156779] RCDC model in Previous version not working in latest version