I know there is a way to use Copy/Paste Nodes, Members, Properties, Materials, etc.Not Talking about the hard way of doing things- which involves trial and error and a lot of clean up. Since the new recommended Workflow is promoting a Physical Mod...

This will reduce the tedious process of turning on and off each design parameter from editor file and then running the full input file again multiple times. If this can be implemented for AISC-360 then it shall be implemented for other codes also.

I assume this has been mentioned before (might even be working on it) but being able to specify the steel design parameters in the Physical Modeler would be a game changer. A separate design module would be good too (sorta how RCDC works), but I d...

Create the ability to use a .dwg or .dxf file as a background when using Staad Physical Modeler. Have clickable nodes in background. Have the ability to place that background at different elevations.

Hi, I have an OpenSTAAD program that generates groups and that applies loads to the elements/beams/nodes in those groups. However I'd like to apply the load to the group directly using openSTAAD as you can in the STAAD Command File? What I want to...

Provide a method for defining surfaces which curve out of plane so that they can be used to create curved walls

currently, only 2 decimal numbers are displayed for plate thickness. when there are different plate thickness are input, and the thickness differences is on the 3rd decimal number, it will be hard to figure out which one is which, since they are d...

In Staad, is there any way to reduce the size of pin symbol and beam orientation symbol? Like support symbols. Thanks

There exists a function to create a new design brief OSDesignUI::CreateDesingBrief(). However, there is no function to remove/delete existing design brief(s). Please review and consider adding this function.

Please could you incorporate some "basic functions" of Excel spreadsheet Tables into "STAAD Results table". This could be a row (with drop down tools) at the Top of the results tables. At the very least, just a few of these functions may help such...