It is hoped that the number of decimal places for the section thickness display can be increased to three, or the display unit of the section can be controlled.
Thank you for posting your idea. I think there is a bigger idea here which is in providing an optional label for any profile. This would assist not only in this situation but also for any parametrically defined profile
e.g.
ELEMENT PROPERTY
3 THICKNESS 0.123 'Display Label'
....
MEMBER PROPERTY
2 PRIS YD 1.234 'Display Label'
Then if you want to use something special to describe the property, the program can use that or else it uses the default as now. Would that seem like a better solution?
Thank you for posting your idea. I think there is a bigger idea here which is in providing an optional label for any profile. This would assist not only in this situation but also for any parametrically defined profile
e.g.
ELEMENT PROPERTY
3 THICKNESS 0.123 'Display Label'
....
MEMBER PROPERTY
2 PRIS YD 1.234 'Display Label'
Then if you want to use something special to describe the property, the program can use that or else it uses the default as now. Would that seem like a better solution?