I consider that the way of using openstaad with VBA is somewhat tedious due to the characteristics of that programming language, therefore, my idea is to propose an openstaad repository but focused on python, which, in my opinion, would facilitate...

Base pressure contour for raft footing is available for the envelop of the loads in Space Gass but not in STAAD. It is important to have this feature be implemented in STAAD too to facilitate the raft footing design based on allowable bearing pres...

Automation of solidity ratio of steel structure for calculating wing load shall be done. It is very time-consuming process for every structure design.

Set parameters and have the program create a plate mesh automatically for finite element analysis.

There should be a way to convert STAAD model to 3D pdf. It will become easy for designers to hover over the model and get clear view of the geometry while modelling in 3D softwares. Inspite of inputs provided, they will have access to 3D pdf where...

When there are many types of load definitions, it is difficult to distinguish which one each load is. If you can customize the name, it will be easier to distinguish and verify

For Inclusion of built up section in standard I section combination with Channel section on top flange, which is widely used for gantry girder.

request to add a future to split/divide a plate element in physical modeler by using a reference line

Under Properties in Analytical Modeling, one can currently only highlight assigned geometry for a single section at a time. A button could be added to the table that allows you to show all section properties in the current view by color, and then ...

Extend the current tapered tube definition to allow for the specification and analysis of tapered rectangular tube profiles (i..e where the length of the two side dimensions differs). Currently STAAD.Pro supports the definition and analysis of tap...