In spite of selecting Metric units for member section properties at the beginning of a new model (considering Indian codes), while checking the member sections during modelling and analysis, the member properties are getting displayed in FPS units...

I consider that the way of using openstaad with VBA is somewhat tedious due to the characteristics of that programming language, therefore, my idea is to propose an openstaad repository but focused on python, which, in my opinion, would facilitate...

Spring supports are created only in a particular direction. For e.g. base/soil springs. negative displacement is considered as compression. what if a steel base plate is to be modelled below a concrete slab. There is no way to create a compression...

Automation of solidity ratio of steel structure for calculating wing load shall be done. It is very time-consuming process for every structure design.

Base pressure contour for raft footing is available for the envelop of the loads in Space Gass but not in STAAD. It is important to have this feature be implemented in STAAD too to facilitate the raft footing design based on allowable bearing pres...

Set parameters and have the program create a plate mesh automatically for finite element analysis.

For Inclusion of built up section in standard I section combination with Channel section on top flange, which is widely used for gantry girder.

There should be a way to convert STAAD model to 3D pdf. It will become easy for designers to hover over the model and get clear view of the geometry while modelling in 3D softwares. Inspite of inputs provided, they will have access to 3D pdf where...

Under Properties in Analytical Modeling, one can currently only highlight assigned geometry for a single section at a time. A button could be added to the table that allows you to show all section properties in the current view by color, and then ...

Extend the current tapered tube definition to allow for the specification and analysis of tapered rectangular tube profiles (i..e where the length of the two side dimensions differs). Currently STAAD.Pro supports the definition and analysis of tap...