STAAD.Pro 2024 output data is published via the Reports module. That data for one structural model can be used to present different subjects. Unfortunately, the 2024 report pages do not include a line in the header to show the "SUBJECT" of that pr...

Requesting to add NSCP 2022 Philippines Seismic Load(similar to ASCE 7-10) addition to STAAD.Pro. Xstructures can provide all formula and technical documentation

STAAD.Pro has offered aluminum design and ASD code checking for many years based on the 1994 Aluminum Design Manual. Since that publication was issued 26 years ago, there have been five subsequent versions released in 2000, 2005, 2010, 2015, and 2...

The accidental eccentricity in staad pro. as per Eurocode 1998:2004, while analyzing the structure for seismic loads using response spectra method.

Create a default way to see the design of one or multiple selected steel beams. Once I select code and "design all". I would like to be able to click on one or more beams and instantly have a button to view the full design input and output. I beli...

In STAAD 2023, if a report is created and the Utilization Ratio table is included, a critical Clause is listed for each member. However, there is no indication in/above the table of which code, or code version, that the Clause pertains to. Please ...

Add function to produce a steel take off immediately without having to run the full analysis.

At present member releases shown as circles at beam ends, makes the view a bit congested with node numbers ON, which makes it difficult to cross verify the DJ1 & DJ2 parameters. if we have an option to scale down the circle (or) introduce a 't...

I am liking this new calculator it super cool. But I have two ideas to build on it 1) The training video that Bentley created to demonstrate this calculator had the demonstrator use the calculator and then open up the input file to delete out the ...

STAAD.Pro- software is using EN1993-1-1 Eurocode 3 2005, - this is not the latest version of this design code. How do we go about updating this in STAAD-Pro ? We need to be using the latest design code for compliance with our EN1090 fabrication wo...