Are there any plans to use the Water Tank module in Structure Wizard in the Physical Modeler to create a retaining wall module? It seems like this could be developed easily from the water tank module.

Hi I have an exceedingly large model which takes hours to run on RCDC. Also, when the model is exported from STAAD to RCDC, all the beam support points are not detected properly by RCDC and I have to spend days just correcting the Beam Continuum. ...

when I use RCDC, the column failed to crack-width,but I want to know the result of failed column crack-width value and calcute to deside how to update the model, update Longitudinal reinforcement or stirrup

Need a function similar to Midas automatic coupling plate element boundary

Pipelink is quite rudimentary. It does not provide the ability to assign guide supports to different nodes. For example, horizontal loads need to be applied to Vertical Members, while vertical loads need to be applied to Horizontal Members. The sa...

Please provide report data in txt format for export in versions after 2023, as we need to maintain consistency with previous versions

Currently in Column Design, RCDC has a limit on the maximum value of the effective length factor and users cannot modify this limit value 5. I want RCDC to lift the restriction on this factor. In my case as per attached staad, Column effective len...

It would be much helpful if additional tools to select entities like Nodes, Beams etc., in the polar coordinate system i.e., specifying the start and end radius (or diameter) and start and end angles. This helps a lot if we need to select the enti...

Staad by default adds some materials to the model (please refer to the snapshot attached). Majority of these will not be used during automation (as the materials will be created separately based on the need) and hence the materials section remains...

Hello dev team, As of now, STAAD cannot show the section shape from section wizard . This issue may make the engineer confuse about local axis even we can referent to the (v,u) axis. its will be good if STAAD can show the section shape that custom...