It would be helpfull if modeled floor slab analysed in STAAD.Pro to be imported in RCDC for designing

Main SA Concrete Design Code SABS 10100-1:2000 Edition 2.2. The Structural use of Concrete Part 1: Design Supplementary SA Concrete Design Codes SABS 10100-2:2014 Edition 3 The Structural use of Concrete Part 2: Materials and Execution of Work SAN...

Can you provide calculations which are similar to the connection design, i.e. include detailed calculations as well as formulas?

It would be useful if Mass Model generator is included in physical Modeller.

Hello, There’s no point in applying the notional load against other lateral loads. In STAAD, it’s possible that the Load Combination where automatically generated so the notional loads are generated for all directions even if they countermeasure t...

Show code check results for more than just the worst case. Should be able to see what the next worst, and next worse after that and so on. It's been over 10 years since I used it but I believe SACS does this. If so, could take a look at it.

OpenSTAAD function to extract the capacity of members, so that it will be used for additional checks as per Code

Hi I have an exceedingly large model which takes hours to run on RCDC. Also, when the model is exported from STAAD to RCDC, all the beam support points are not detected properly by RCDC and I have to spend days just correcting the Beam Continuum. ...

automated tool for hydrostatic loading should be included