As of now, STAAD. Pro supports the older version of IS 802, specifically IS 802:1995, for the design of steel structures such as gantry structures and equipment support structures The updated version, IS 802:2023, which includes revised load facto...

Direct Interoperability and Intelligent Mapping: Integrate STAAD Pro, STAAD Foundation, Revit, and Advance Steel with native plugins or features for one-click model transfers. Implement an automatic and precise mapping system for materials and sec...

If i create any member using "Shape Editor" using built up members (Stadd pro version 24.00.02.354), then during "3d rendering" it shows only line diagram. Although this problem is continuing from the earlier version also. Is ther any solutions of...

I have several spread footing analysis, and some indicate fail/pass as failed in red color, but bearing capacity is OK, now, I can see that safety factor is not OK by hovering the cursos over the footing, but that is all, I don't know the cause or...

in standard section data base only 90Deg hat is available, we are mostly using 75Deg hat

In light of the increasing opportunities in the construction business in Brazil, we strongly hope that STAAD Pro will support the Brazilian codes "NBR" in STAAD Pro. Specifically, we would like to see the following representative NBR codes include...

Sometimes, a member requires the assignment of a Beta Angle for a particular member, but after some iterations, it might not be needed. In the Beta Angle assignment tab, when someone defines a Beta Angle, it exists—but Beta Angle 0 is removed. In ...

There is currently no way, other than directly adding rigid body members with the necessary releases, to simulate an an axial angle or tee member (brace) under eccentric axial load. This causes a high amount of manual calculations to determine the...

Currently only rigid diaphragm option exists in Staad, we need to account for flexible diaphragms.