Hello dev team, As of now, STAAD cannot show the section shape from section wizard . This issue may make the engineer confuse about local axis even we can referent to the (v,u) axis. its will be good if STAAD can show the section shape that custom...

In recent times, I have been designing a large number of buried underground structures. (I figured many Engineers may have similar experiences on this too). For buried structures, a few of the applied loads are a function of a single variable i.e....

Hi I have an exceedingly large model which takes hours to run on RCDC. Also, when the model is exported from STAAD to RCDC, all the beam support points are not detected properly by RCDC and I have to spend days just correcting the Beam Continuum. ...

Could you please add shortcut to view Plate stresses Graphical Contours ( Mx, My, Mxy, SQx, SQy, Sx, Sy) in the Customize quick commands Pop-Up shortcut using space bar. The current function only brings up tables which is a bit cumbersome when mak...

Need a function similar to Midas automatic coupling plate element boundary

Please find the combination of three models by different engineer. Under this when finally local stresses are checked, the contours are not smooth. if by any chance local axis of elements can be change, this will same a valuable time of re modelli...

Currently, if there are multiple design blocks present in a STAAD model, in the post-processing utilization table, design ratio from the last design block is reported. It is very common to define multiple design blocks with different set of parame...

Pipelink is quite rudimentary. It does not provide the ability to assign guide supports to different nodes. For example, horizontal loads need to be applied to Vertical Members, while vertical loads need to be applied to Horizontal Members. The sa...

It will be helpful if a function for applying the hydrostatic forces on plate elements either by selecting a group of plates or a selecting a single plate e.g., the PlateID and the pressure at four corners of the plate. Many a times applying the p...

Please provide report data in txt format for export in versions after 2023, as we need to maintain consistency with previous versions