Currently, if there are multiple design blocks present in a STAAD model, in the post-processing utilization table, design ratio from the last design block is reported. It is very common to define multiple design blocks with different set of parame...

Structure discontinuties provided for thermal expansion isn't allowed in dynamic analysis, so provide feature so that we can analyse such structure without separating the model in individual file..

It will be helpful if a function for applying the hydrostatic forces on plate elements either by selecting a group of plates or a selecting a single plate e.g., the PlateID and the pressure at four corners of the plate. Many a times applying the p...

Hi I have an exceedingly large model which takes hours to run on RCDC. Also, when the model is exported from STAAD to RCDC, all the beam support points are not detected properly by RCDC and I have to spend days just correcting the Beam Continuum. ...

Widely used in industry

Need a function similar to Midas automatic coupling plate element boundary

Staad should have one option which helps to create a report of node labels ( tier/levewise) for whole structure. Also a report of beam labels ( tier / levelwise) for the whole structure. Also report of section property ( tier/levelwise) for whole ...

Pipelink is quite rudimentary. It does not provide the ability to assign guide supports to different nodes. For example, horizontal loads need to be applied to Vertical Members, while vertical loads need to be applied to Horizontal Members. The sa...

Please provide report data in txt format for export in versions after 2023, as we need to maintain consistency with previous versions

It would be much helpful if additional tools to select entities like Nodes, Beams etc., in the polar coordinate system i.e., specifying the start and end radius (or diameter) and start and end angles. This helps a lot if we need to select the enti...