If the slenderness ratio meets the requirements, but its normalized ratio is not shown in the utilization table, can the slenderness ratio be added to the utilization table, which will help the designer to understand the condition of the member.

Can you provide calculations which are similar to the connection design, i.e. include detailed calculations as well as formulas?

It would be useful if Mass Model generator is included in physical Modeller.

It'd be nice to be able to use the take-off command on plate elements. Similarly to beams where the take off give the section, length, and weight. Having the take off give thickness, area, and weight would be really helpful.

All features of ADINA should be implemented and available in staad pro also. Like, Non-linear dynamics analysis, hydrodynamic (impulsive & compulsive sloshing load), Computational fluid dynamics, Potential fluid dynamics, Modelled of water in ...

automated tool for hydrostatic loading should be included

Anyone who perform post-processing/detailed analysis on plated structures will benefit from this. The function could take a plate ID and loadcase as input, and give plate corner stresses for all corners as output.

The new report formatting while nice in appearance is cumbersome, not quick to use and has issues with savings....can't there be an ability for staad users to "revert" back to the old school report formatting?

I chose this "add idea" route because I couldn't find another channel to communicate my disappointment as stated below. Report setup in STAAD. Pro 2024 is not good. It gives poor quality picture compared to previous versions. This kind of weird pr...

Currently, it is possible to display results for multiple design blocks with AISC360-16 results only. This feature is also required for AIJ2005 and 2002. In AIJ codes, load cases are classified into parmanent loads, temporary loads and loads for...