This will reduce the tedious process of turning on and off each design parameter from editor file and then running the full input file again multiple times. If this can be implemented for AISC-360 then it shall be implemented for other codes also.

All features of ADINA should be implemented and available in staad pro also. Like, Non-linear dynamics analysis, hydrodynamic (impulsive & compulsive sloshing load), Computational fluid dynamics, Potential fluid dynamics, Modelled of water in ...

Hi, I have an OpenSTAAD program that generates groups and that applies loads to the elements/beams/nodes in those groups. However I'd like to apply the load to the group directly using openSTAAD as you can in the STAAD Command File? What I want to...

The new report formatting while nice in appearance is cumbersome, not quick to use and has issues with savings....can't there be an ability for staad users to "revert" back to the old school report formatting?

I chose this "add idea" route because I couldn't find another channel to communicate my disappointment as stated below. Report setup in STAAD. Pro 2024 is not good. It gives poor quality picture compared to previous versions. This kind of weird pr...

Have the material properties from the Staad analysis import from staad.

currently, only 2 decimal numbers are displayed for plate thickness. when there are different plate thickness are input, and the thickness differences is on the 3rd decimal number, it will be hard to figure out which one is which, since they are d...

We are really appreciate that rebar 6 and 9 mm were added to RCDC recently(update2023). But we would like to request another function that the fy can be assigned to specific rebar number and also differ to each rebar. For example, If we have RB 9m...

In Staad, is there any way to reduce the size of pin symbol and beam orientation symbol? Like support symbols. Thanks

I would like to import a Staad model to SFA then design a pile cap based on the reactions and then design the piles supporting the pile cap. I see that there is a drilled pier module within plant foundations, but I can't seem to import the loads. ...