I would like a new feature to be implemented in RCDC, when generating footing drawings , starter bar for the columns should be included in every footing detail as shown in the attached picture

This is very usefull in viewing, selecting to view, viewing whole structure without zooming out etc. This will make STAAD pro operation faster.

currently if anyone need to add the beams in group definition, all the beams including existing added need to be selected. if new beams can be added without selecting existing beams, it will be easier

In load data page when you select any specific UDL or point load, then the UDL or point load associated beam and node shall be auto selected or highlighted. this will help to identify if load applied is at right location or not

While generating Report, Company Logo needs to be changed for every project, that is a tedious practice. The changes should be permanent and for company.

Because you must create multiple wind definitions for wind along a single direction (i.e. windward, leeward, sidewall) it would be helpful to have the ability to combine these in a single load case. Combining them in the load combos is cumbersome....

There is the command NSF that modifies the net area of the whole member, but there isn't a command to modify the net area of the tension flange only to apply it to section F13 in AISC.