Please include the interaction diagram in the calculation output report for pedestals in STAAD Foundation Advanced 2024, as was done in version V9. Currently, the report shows the coordinates of the load points but does not include the associated ...

Currently only rigid diaphragm option exists in Staad, we need to account for flexible diaphragms.

At present, only storey drift & displacements are reported. There is a need to include storey shear values for both the X and Z directions to support comprehensive analysis.- There is an enhancement request already in place for this. For Euroc...

Currently, accidental torsion analysis is only supported when using the Standard response spectrum excluding Eurocode, which needs to be specified. The functionality is not available for Custom spectra, which is a critical limitation that needs to...

If i create any member using "Shape Editor" using built up members (Stadd pro version 24.00.02.354), then during "3d rendering" it shows only line diagram. Although this problem is continuing from the earlier version also. Is ther any solutions of...

In most projects, equal angle sections are commonly used. However, the current section database includes a combined list of both equal and unequal angle sections under the same category. To improve workflow efficiency, we request that these be sep...

There is currently no way, other than directly adding rigid body members with the necessary releases, to simulate an an axial angle or tee member (brace) under eccentric axial load. This causes a high amount of manual calculations to determine the...

For the design of double angle sections, the software currently does not perform the design due to the inability to plot buckling curves. An option to manually select buckling curves for both cases should be provided to enable proper design of the...

In light of the increasing opportunities in the construction business in Brazil, we strongly hope that STAAD Pro will support the Brazilian codes "NBR" in STAAD Pro. Specifically, we would like to see the following representative NBR codes include...

Currently, using the Design.AssignDesignCommand function to add a design command like "CODE CHECK" is ideal only for one execution using VBA. If you execute the code multiple times, the "CODE CHECK' command is added to the command equal to the num...