Beam FB111 is secondary beam and beam FB347 to FB350 is primary beam. We want beam numbering reverse. Primary beam should have one number and secondary beam should split into four different numbers. We don't want group name in output file.

Looking for a OpenSTAAD Function to extract Area of reinforcement from STAAD Output. I have explored the OpenSTAAD help and I couldn't able to find. If you have any solutions, please suggest.

In design of buildings sometimes we need to takeup tapered bracket or counterbalance supported tapered cantilever cross section At the moment we can not design tapering cross section in staad pro connection edition

Optimization of steel structure in staad pro as per (Indian code like IS-800 _2007, IS-801 etc. has many limitations till now. It has to be resolved earlier, Some of limitations are ~ optimization for tapered sections not supported by staad ~ opti...

Now a days, construction of high rise building are very common in India, and it is very necessary to implement code for the same like IS 16700 with new amendments in 2023, kindly implement the same in staad as early stage, with all clauses like co...

Hi I have an exceedingly large model which takes hours to run on RCDC. Also, when the model is exported from STAAD to RCDC, all the beam support points are not detected properly by RCDC and I have to spend days just correcting the Beam Continuum. ...

Pipelink is quite rudimentary. It does not provide the ability to assign guide supports to different nodes. For example, horizontal loads need to be applied to Vertical Members, while vertical loads need to be applied to Horizontal Members. The sa...

Please provide report data in txt format for export in versions after 2023, as we need to maintain consistency with previous versions

It is understood that while performing response spectrum analysis, the scale factor (V_b/V_B ) Where,V_b=Equivalent static base shear,〖 V〗_B Response spectrum base shear), is automatically accounted for calculation of design base shear. But,this s...

Are there any plans to use the Water Tank module in Structure Wizard in the Physical Modeler to create a retaining wall module? It seems like this could be developed easily from the water tank module.