Extend the current tapered tube definition to allow for the specification and analysis of tapered rectangular tube profiles (i..e where the length of the two side dimensions differs). Currently STAAD.Pro supports the definition and analysis of tap...
implement front to front angle configuration in STAAD
In India many Columns are made with 4 leg of angle with lacing of rod or angle(built-up) STAAD have option of design back to back but it is not have front to front angle configuration
If the slenderness ratio meets the requirements, but its normalized ratio is not shown in the utilization table, can the slenderness ratio be added to the utilization table, which will help the designer to understand the condition of the member.
I think the wind load application should be rewritten to make it simpler and more user friendly. STAAD is at least three times as long as SAP2000 when inputting wind loads.
Staad Pro Structure Wizard (StWizard) - Pan & Zoom
For the Structure Wizard in the Analytical workflow:- Mouse Zoom behavior could be aligned with that of the STAAD interface (in STAAD - scroll up is zoom-in and scroll down is zoom-out) Pan by mouse could be advantageous, so is exiting the PAN mod...
about 1 year ago
in STAAD.Pro
2
Will not implement
Steel Auto-Drafter draws member releases with a 20mm offset by default. The user would like to set this offset distance to an arbitrary distance.
Additionally, the user would like to set separate distances for each of the following members:
...
almost 2 years ago
in STAAD.Pro
6
Future consideration