Dear Colleagues, // STAAD.Pro CONNECT Edition - Version 22.12.00.142 // there was a situation where we had to find out the lateral forces due to wind on a light pole (tapered profile) and provide suitable support for the same. Wind was applied usi...

The AutoForm tool helps speed up generation of PMembers within an analytical modeler. Would be nice to have the ability to number physical members similar to how nodes and analytical elements like beam, plate, and solid elements are renumbered.

In the new 2023 version, the new report builder doesn't allow you to include the failed member list when there aren't any failed members. v22 did allow for that and would report there are no failed members. Which was an easy concise way of saying ...

STAAD.Pro- software is using EN1993-1-1 Eurocode 3 2005, - this is not the latest version of this design code. How do we go about updating this in STAAD-Pro ? We need to be using the latest design code for compliance with our EN1090 fabrication wo...

we conventionally add a new job and assign all the parameters from scratch while trying to replicate a similar footing desing within the same STAAD.Foundation file. however adding a cop/replicate/clone job might save time avoid the chance of missi...

Need an Option to Design Beam supported by RC Column at one end and Steel bracket at other end. Currently RCDC doesn't recognize steel cupport and designing a beam s Cantilever which is not actual condition. This kind of Beam arrangment is require...

For the eurocode to calculate automatically the factors C1,C2,C3 to calculate correctely the Mcr value for elements. Which depends on the bending moment diagram, loading type and support conditions.

Under Properties in Analytical Modeling, one can currently only highlight assigned geometry for a single section at a time. A button could be added to the table that allows you to show all section properties in the current view by color, and then ...

The accidental eccentricity in staad pro. as per Eurocode 1998:2004, while analyzing the structure for seismic loads using response spectra method.

it might also be helpful, if we can add the MERGE NODE tool in the "popup" Node tools when many nodes are selected (just like MERGE BEAM tool is included in the "popup" Beam tools) and the CONNECT BEAMS and COLLINEAR BEAMS tool also (to generate b...