Kindly make provision for Hat section with Lips( straight lip and inclined lip) in the section database. Please make it such a way that if we enter the depth, width, thickness and give "generate" and all the properties gets generated automatically...

The STAAD.Pro now can not check the the vertical structural irregularities 5a/5b in the ASCE 7 table 12.3-2 by ant command stream, but as the code demand, the designer need check this irregularities, it is very difficult and cost time for designer...

As most of the functions exposed in OpenSTAAD uses the surfaceId to target a specific parametric surface, a function to retrieve the Id of the parametric surface by specifying it's name will be essential. I tried using the existing function GetPar...

Usually we start creating the parametric surface mesh by assigning a name. However, there will be situations where we need to clear all the existing mesh definitions and then start afresh. It will be much helpful if there is a function in OpenSTAA...

It would be good to get a function in OpenSTAAD function to get the CoG of the Model.

There is currently no efficient way to consider the live load reduction factor in STAAD.Pro. It would be fantastic to add a parameter to the design section (e.g., under CSA S16-19 or AISC 360-16) to consider a live load reduction on an element by ...

Can we have a single query where we can have both the Bending Moments, and Shear forces can be sketched in the query report? adding the Deflection Diagram would also be an added advantage.

Hi, Typically, to get end forces to design the connection for a certain beam size, a group is created and the bounding beam forces for the group are extracted using the "Beam Results - Beam Forces - Summary table" using the "Results Setup - Range ...

Please add the ability to automatically generate wind loading to eurocodes.