I think that the numbering on Load Group, Primary Load Case and Load combination spreadsheet should be customizable. This is very important when dealing with several design parameter and/or analysis load groups.

Currently saved report setups are only available to the model it was saved in. The user should have the ability to load a report template that he created that can be used for any job.

The way like STAAD physical has it now allows to create only one by one panels with pressure redistribution only in x or Z direction. Just inclined members in the attached sketch cannot be loaded with parallel or perpendicular directions. Also it ...

May you add an option for choosing the strength stirrups in RCDC,by default is 250 but when i want to use stirrup of 410 its not possible to change its strength in RCDC

The Plate Center Stress table has Global Moments as one of the tabs. However there is no Summary tab corresponding to Global Moments that can enable the user to find out the maximum quickly.

Allow offset to be changed in dialog that appears when double-clicking member similar to how Beta angle can be edited. Sometimes I may have over a hundred offset commands. If I need to change the offset of a particular member I have to step throug...

I often create models with multiple support conditions. Because of STAAD's requirements on support degrees of freedom I have to model lift cases first. This means that I cannot model seismic cases first as required if I want to use STAAD's seismic...

Please add HSS8x8x5/8 to the pull-down list in under Select Profile > ASTM > HSS - Square in Section Wizard.

I think the interoperability between STAAD and ram connection is very useful and That it reduces the time of the design greatly. What I would like to suggest is that the users be able to export the connection data and 3D details from the connectio...

Worley NZ, van Tonder, Gideon (New Plymouth) <Gideon.vanTonder@worley.com> has requested for Projected Area loading for plates just like we have for members.