Hi, Typically, to get end forces to design the connection for a certain beam size, a group is created and the bounding beam forces for the group are extracted using the "Beam Results - Beam Forces - Summary table" using the "Results Setup - Range ...

Show code check results for more than just the worst case. Should be able to see what the next worst, and next worse after that and so on. It's been over 10 years since I used it but I believe SACS does this. If so, could take a look at it.

Anyone who perform post-processing/detailed analysis on plated structures will benefit from this. The function could take a plate ID and loadcase as input, and give plate corner stresses for all corners as output.

Would like to get implemented NBC 2015 Code parameter.

OpenSTAAD function to extract the capacity of members, so that it will be used for additional checks as per Code

Currently RCDC works only in Euro code for water tank.. my suggestion is please consider IS:3370 for water tank design.

The STAAD.Pro now can not check the the vertical structural irregularities 5a/5b in the ASCE 7 table 12.3-2 by ant command stream, but as the code demand, the designer need check this irregularities, it is very difficult and cost time for designer...

It is suggested to add I sections with side plates table under specifications user table manager tabs. Offshore brownfiled modificaitons work would involve adding side plates to existing I sections to increase its capacity.

It would be good to get a function in OpenSTAAD function to get the CoG of the Model.

Staad foundation advance (SFA) has an option to assign plates of various thickness, but it should also have an option to model such plates in TRAPEZOIDAL PATTERN as shown in below images,which is frequently used to model raft foundation, also plac...