While generating Report, Company Logo needs to be changed for every project, that is a tedious practice. The changes should be permanent and for company.

Please consider adding an autosave feature. A real autosave not a prompt that appears every so often minutes asking you to save. One that will autosave without input. Autosave is pretty much a standard now across a variety of softwares, so constan...

We request to at the OpenSTAAD function to renumber Nodes just like we do with beams.

Within the Annotation Menu, could you include Plates Stresses & Nodal Forces ? This will be very useful to display specific plate /nodal results during compilation of Structural reports. Given that the contours only show a range of values. Thi...

This might be difficult to implement, but it might be nice if you could label the node numbers in the physical modeler different than used in the analytical modeler so that you could keep those nodes the same. Therefore, they would show up the sam...

It is hoped that the API SPEC 4F standard can be added, and the wind load can be quickly loaded in 45°, 135°, and so on.

These could be used when performing member or shell design in STAAD.Pro, as well as Advanced Concrete design. See applicable snapshots attached. User would like to be able to do design to NZ codes in STAAD.Pro (specifically concrete and timber,...

dear teams,please make corrects for software when you design water tank with slab including beams,RCDC not reading beams,plz correct it,thanks in advance

It should work similarly to code checking steel members according to EN 1993-1-1. It would benefit everyone designing aluminum structures due to highly corrosive environments and/or weight restrictions.