It would be nice to have such a command, instead to do several selections, and than to use Invert selection.

During design of beam in rcdc,if i put a check of crack width the software will not design and it gives a message written "Cannot find column [StAstTop] but if i dont check for crack width the software works perfectly.Need a help on this problem b...

May you please add RC Designer in the next update of Staad pro CE

May you please improve the design of foundation of parametric wall in RCDC,lets say if i want my footing size to be 1500mm by 300mm depth,but the left side i want it to be 400mm from centre of wall and right side to be 1100mm from centre of wall,c...

In the Loads window when you pick an existing load it highlights that load clearly. However, if you then click into the model window, say, to assign a member to that load, it changes it to a very light grey background. If you are going down the li...

In a way as STAAD has it now is not practical for usage.

I highly recommend to include calculation of vertical seismic load using NBCC 2010/2015 . I see it as a big gap in Staad Pro not to include calculation of vertical seismic loading using NBCC 2010/2015

Improvement should be done on RC wall, during modelling on places of RC wall i don't place beam on top of the wall because the wall it self act as a beam,but when it comes to assign of floor load in places where there is no beam on RC wall the flo...

I've had trouble using rigid diaphragms in the Physical Modeler. When I select a group of nodes and assign them a diaphragm all at once the diaphragm produces an error in the Analytical Modeler. When I add the same nodes to a diaphragm one by one ...