Unless I am mistaken in order to run a direct analysis, you specify notional loads. However, per the specification it is allowable to use direct modeling of imperfections per C.2a. There is a way to specify camber and drift for members, but from w...

Kindly add open staad function to remove selected member loads. Thank you.

Extend existing STAAD.Pro to ADINA interop to export cross-section dimensions in addition to the existing "General" cross-section type so that nonlinear elastic-plastic material can readily be applied to beeam elements.

Add the concrete design code for environmental structures into STAAD for designing water retaining structures.

The environmental design of concrete needed for water retaining structures

I think it is a good idea to allow users to name their Tapered sections as with the prismatic sections or sections created by user table. Because many times user creates many tapered sections in his model, andt when it comes to modifying one of th...

The Staad Analytical modeler interface need more mouse controls. For example, the model rotate options using mouse left/right bottoms, Zoom options using mouse wheel buttons etc. should be introduced in the analytical modeler. This option is alrea...

Provide the Turkish Seismic Code (TBSC-2018) which was updated in 2018 for static seismic and response spectrum loading. Code attached.

A print command such as "PRINT JOINT FORCES LIST 1 2 3 etc." that would output all the member end forces at a specified node, for the specified load cases. This is currently possible using macros/openSTAAD, but would be very helpful if added to th...