RAM connection design cannot be used in a model with SET Z UP specified. This is a crippling limitation of the software.

Dear Colleagues, // STAAD.Pro CONNECT Edition - Version 22.12.00.142 // there was a situation where we had to find out the lateral forces due to wind on a light pole (tapered profile) and provide suitable support for the same. Wind was applied usi...

Currently in staad foundation max/min bearing pressure is shown only for the compression cases.Incase the minimum pressure is governed in uplift case the same is not shown in the summary table.Same can be updated in upcoming revisions.Also the bea...

Under Properties in Analytical Modeling, one can currently only highlight assigned geometry for a single section at a time. A button could be added to the table that allows you to show all section properties in the current view by color, and then ...

it might also be helpful, if we can add the MERGE NODE tool in the "popup" Node tools when many nodes are selected (just like MERGE BEAM tool is included in the "popup" Beam tools) and the CONNECT BEAMS and COLLINEAR BEAMS tool also (to generate b...

I wouldn't lie by saying that I'm a vivid user of the calculator from the withing the Input Editor/Command file. But at times when the Window's calculator crashes, Staad's calculator comes to the rescue. hoping to add a few suggestions: 1. rather ...

It is general practice if we assigned a new property for the members, the old property will be automatically replaced or deleted by the new one. No need to change or edit the property in input file for members one by one. But for some large file I...

In the new 2023 version, the new report builder doesn't allow you to include the failed member list when there aren't any failed members. v22 did allow for that and would report there are no failed members. Which was an easy concise way of saying ...

The STAAD.Pro now can not check the the vertical structural irregularities 5a/5b in the ASCE 7 table 12.3-2 by ant command stream, but as the code demand, the designer need check this irregularities, it is very difficult and cost time for designer...