To determine stability analysis of raft foundation in SFA, Automatic features (by few clicks) is not available in SFA, rather much more manual, repetative, tedious and time consuming process, which lessens the efficiency and deliverables of softwa...

For designing of "ring wall foundation" in SFA, as of now, only "Ground supported ring wall foundation design" available in SFA. But "Pile supported ring wall foundation design " isn't available. So it is necessary to implement the same in SFA.

your soft does not support codes for designing as per Indian Codes request if you could incorporate the same since the software is a wonder full product

similar to the sliding & uplift factors, would be helpful if there's an option to enter Overturning safety factor also.

Please add one open STAAD function in which we can edit existing tapper property it will same much time

Currently, the only way to use STAAD.pro fireproofing specification is thru the Analytical Modeler. If you have a physical model, you have to break the connection and then edit the Input file to remove the "DO NOT EDIT" restrictions so that you ca...

At present member releases shown as circles at beam ends, makes the view a bit congested with node numbers ON, which makes it difficult to cross verify the DJ1 & DJ2 parameters. if we have an option to scale down the circle (or) introduce a 't...

I believe there is no option or command to directly view RC members that have failed, similar to that of "Utility" option available for checking failure of steel members. Failure of RC members must be manually checked from the "Analysis Output" op...

This check should be implemented in RCDC as we know during design the reinforcement area maybe needed to be increased in order to pass the beam deflection check