RCDC - Beam Design - Long term deflection check should be available
For the structures like Metro railway station and Industrial buildings, Clients are demanding to perform the long-term deflection check of the beam. RCDC should allow to perform the long-term deflection check for the beams selected by the user. Ge...
Dear Colleagues, // STAAD.Pro CONNECT Edition - Version 22.12.00.142 // there was a situation where we had to find out the lateral forces due to wind on a light pole (tapered profile) and provide suitable support for the same. Wind was applied usi...
about 2 years ago
in STAAD.Pro
1
Future consideration
Allow an option to include Failed Member list in the report even when there are no failed members
In the new 2023 version, the new report builder doesn't allow you to include the failed member list when there aren't any failed members. v22 did allow for that and would report there are no failed members. Which was an easy concise way of saying ...
over 1 year ago
in STAAD.Pro
1
Future consideration
STAAD.Pro- software is using EN1993-1-1 Eurocode 3 2005, - this is not the latest version of this design code. How do we go about updating this in STAAD-Pro ? We need to be using the latest design code for compliance with our EN1090 fabrication wo...
about 1 year ago
in STAAD.Pro
1
Future consideration
Need Option in RCDC to Design Beam supported by RC Column at one end and Steel bracket at other end
Need an Option to Design Beam supported by RC Column at one end and Steel bracket at other end. Currently RCDC doesn't recognize steel cupport and designing a beam s Cantilever which is not actual condition. This kind of Beam arrangment is require...
adding clone job in the 'job setup' in STAAD Foundation
we conventionally add a new job and assign all the parameters from scratch while trying to replicate a similar footing desing within the same STAAD.Foundation file. however adding a cop/replicate/clone job might save time avoid the chance of missi...
AUTOMATIC BUCKLING EUROCODE COEFFICIENTS C1,C2,C3 and K.
For the eurocode to calculate automatically the factors C1,C2,C3 to calculate correctely the Mcr value for elements. Which depends on the bending moment diagram, loading type and support conditions.
Add ability to show "Color by Section" under Properties Tab
Under Properties in Analytical Modeling, one can currently only highlight assigned geometry for a single section at a time. A button could be added to the table that allows you to show all section properties in the current view by color, and then ...
Add an option for optimize to specify equal leg angles.
It would be nice to tell the optimizer to optimize to angles where the angle legs are equal. By default I prefer to specify equal legs, as it eliminates confuse and chances of error when the legs are the same size. So even if the optimizer suggest...