The automatic generation of wind load should be made available to Indian code also apart from American code. It will save lot of time in analysis and manual calculation.

Please allow user to remove multilinear springs in GUI rather than going into the editor to remove 1 or 2 lines of text.

Staad should have one option which helps to create a report of node labels ( tier/levewise) for whole structure. Also a report of beam labels ( tier / levelwise) for the whole structure. Also report of section property ( tier/levelwise) for whole ...

Hello, I found a problem when I have to analyze a structure in two different situation. One with equipment in operation and another one with equipment empty. For eatrhquake I used "Response spectra". It is knows that response spectra use only the ...

It is understood that only for AISC 360 design checks, it is feasible to view the design results for different design parameters & maximum case, while the same is not allowed for other design codes without going in to output file. Appreciate t...

ear Eng: I was Suggest if we can do the following - generate the drawings with the legend "Rxx" ? - Replace the current table shown in the snapshot with the section properties table attached the snap shot that can show the required

When a physical member is created, STAAD should handle the collection of beams as one entity. When a section of material is assigned, it should always be to the physical member. End releases will only exist at the ends of the physical member. Curr...

The possibility to presents diagrams with annotation is very importent for the documentation of analysis. Today the annotation of values for forces, moments, dispacements and so on does often clash with the geometry plot. The possibilites to adjus...