Please find the combination of three models by different engineer. Under this when finally local stresses are checked, the contours are not smooth. if by any chance local axis of elements can be change, this will same a valuable time of re modelli...

I would like a new feature to be implemented in RCDC, when generating footing drawings , starter bar for the columns should be included in every footing detail as shown in the attached picture

This is very usefull in viewing, selecting to view, viewing whole structure without zooming out etc. This will make STAAD pro operation faster.

Because you must create multiple wind definitions for wind along a single direction (i.e. windward, leeward, sidewall) it would be helpful to have the ability to combine these in a single load case. Combining them in the load combos is cumbersome....

There is the command NSF that modifies the net area of the whole member, but there isn't a command to modify the net area of the tension flange only to apply it to section F13 in AISC.

Kindly add open staad function to remove selected member loads. Thank you.

Extend existing STAAD.Pro to ADINA interop to export cross-section dimensions in addition to the existing "General" cross-section type so that nonlinear elastic-plastic material can readily be applied to beeam elements.