In India many Columns are made with 4 leg of angle with lacing of rod or angle(built-up) STAAD have option of design back to back but it is not have front to front angle configuration

If the slenderness ratio meets the requirements, but its normalized ratio is not shown in the utilization table, can the slenderness ratio be added to the utilization table, which will help the designer to understand the condition of the member.

Can you provide calculations which are similar to the connection design, i.e. include detailed calculations as well as formulas?

It would be useful if Mass Model generator is included in physical Modeller.

It'd be nice to be able to use the take-off command on plate elements. Similarly to beams where the take off give the section, length, and weight. Having the take off give thickness, area, and weight would be really helpful.

automated tool for hydrostatic loading should be included

All features of ADINA should be implemented and available in staad pro also. Like, Non-linear dynamics analysis, hydrodynamic (impulsive & compulsive sloshing load), Computational fluid dynamics, Potential fluid dynamics, Modelled of water in ...

Anyone who perform post-processing/detailed analysis on plated structures will benefit from this. The function could take a plate ID and loadcase as input, and give plate corner stresses for all corners as output.

The new report formatting while nice in appearance is cumbersome, not quick to use and has issues with savings....can't there be an ability for staad users to "revert" back to the old school report formatting?

I chose this "add idea" route because I couldn't find another channel to communicate my disappointment as stated below. Report setup in STAAD. Pro 2024 is not good. It gives poor quality picture compared to previous versions. This kind of weird pr...