Within the Annotation Menu, could you include Plates Stresses & Nodal Forces ? This will be very useful to display specific plate /nodal results during compilation of Structural reports. Given that the contours only show a range of values. Thi...

This might be difficult to implement, but it might be nice if you could label the node numbers in the physical modeler different than used in the analytical modeler so that you could keep those nodes the same. Therefore, they would show up the sam...

I would like a new feature to be implemented in RCDC, when generating footing drawings , starter bar for the columns should be included in every footing detail as shown in the attached picture

This is very usefull in viewing, selecting to view, viewing whole structure without zooming out etc. This will make STAAD pro operation faster.

It is hoped that the API SPEC 4F standard can be added, and the wind load can be quickly loaded in 45°, 135°, and so on.

Because you must create multiple wind definitions for wind along a single direction (i.e. windward, leeward, sidewall) it would be helpful to have the ability to combine these in a single load case. Combining them in the load combos is cumbersome....

When completing a design in RCDC if the member fails, you cannot edit the rebar. I would like to be able to edit reinforcement. Then after the reinforcement is added, I would like it to print a full report so I can see what is failing. This is so ...

It should work similarly to code checking steel members according to EN 1993-1-1. It would benefit everyone designing aluminum structures due to highly corrosive environments and/or weight restrictions.

There is the command NSF that modifies the net area of the whole member, but there isn't a command to modify the net area of the tension flange only to apply it to section F13 in AISC.