It is highly inefficient to require the user to switch cursors for each selection in STAAD. STAAD shall identify the context of operation automatically, and select the object required. Users should be able to select nodes, beams, plates, loads, te...

There should be a feature in RCDC whereby you can group selected footing for combine footing design and detailing. Or, after RCDC is finish footing designs and the distance between adjacent footings are below a specified minimum, then RCDC should ...

As of now, moving load feature is available only in vertical plane. But moving load in horizontal plane isn't available yet. But, as per industry demand, moving load to be applied longitudinal and transverse direction, simultaneously. Staad pro s...

Currently in staad foundation max/min bearing pressure is shown only for the compression cases.Incase the minimum pressure is governed in uplift case the same is not shown in the summary table.Same can be updated in upcoming revisions.Also the bea...

STAAD Pro CONNECT Edition shows a warning based on IS 1893 part 1:2002, when the latest code available currently under use is IS 1893 part 1:2016. Kindly clarify why should warnings based on old codes appear when the user has specifically selected...

For the structures like Metro railway station and Industrial buildings, Clients are demanding to perform the long-term deflection check of the beam. RCDC should allow to perform the long-term deflection check for the beams selected by the user. Ge...

ANL file for steel code has changed format can you revert back again or atleast put to option on Track command to retain original format.

Currently, the only way to use STAAD.pro fireproofing specification is thru the Analytical Modeler. If you have a physical model, you have to break the connection and then edit the Input file to remove the "DO NOT EDIT" restrictions so that you ca...

we conventionally add a new job and assign all the parameters from scratch while trying to replicate a similar footing desing within the same STAAD.Foundation file. however adding a cop/replicate/clone job might save time avoid the chance of missi...

I believe there is no option or command to directly view RC members that have failed, similar to that of "Utility" option available for checking failure of steel members. Failure of RC members must be manually checked from the "Analysis Output" op...