Create a default way to see the design of one or multiple selected steel beams. Once I select code and "design all". I would like to be able to click on one or more beams and instantly have a button to view the full design input and output. I beli...

Currently, water tank design is only available for the Euro Code. Please update for use with current ACI code.

The new report formatting while nice in appearance is cumbersome, not quick to use and has issues with savings....can't there be an ability for staad users to "revert" back to the old school report formatting?

I chose this "add idea" route because I couldn't find another channel to communicate my disappointment as stated below. Report setup in STAAD. Pro 2024 is not good. It gives poor quality picture compared to previous versions. This kind of weird pr...

It is highly inefficient to require the user to switch cursors for each selection in STAAD. STAAD shall identify the context of operation automatically, and select the object required. Users should be able to select nodes, beams, plates, loads, te...

similar to the sliding & uplift factors, would be helpful if there's an option to enter Overturning safety factor also.

Add function to produce a steel take off immediately without having to run the full analysis.

In STAAD 2023, if a report is created and the Utilization Ratio table is included, a critical Clause is listed for each member. However, there is no indication in/above the table of which code, or code version, that the Clause pertains to. Please ...

At present member releases shown as circles at beam ends, makes the view a bit congested with node numbers ON, which makes it difficult to cross verify the DJ1 & DJ2 parameters. if we have an option to scale down the circle (or) introduce a 't...

The "actual ratio" button in postprocessing mode is not working for a lot of users in Subsea7. This button is supposed to re-arrange beam utilizations from default beam number order, to utilization ascending order, and is very helpful. The problem...