The pipelink transfer of loads from AutoPIPE to STAAD is currently very limited for guide-type supports and other multi-direction supports. A guide support will have vertical loads as well as lateral loads. Depending on the direction of the latera...

To streamline the design process using the OpenSTAAD function, we aim to automate the visualization of member stress ratios for each analysis. Currently, when employing the "objOpenSTAAD.View.SetModeSectionPage 1, 6, 19" function, the stress ratio...

When designing concrete members in Staad.Pro, detailed design information can be seen in batch mode using TRACK command. One useful detail is the design ratio Pu/Pn. If that value can be shown the same way is shown for steel design it can speed up...

It is understood that only for AISC 360 design checks, it is feasible to view the design results for different design parameters & maximum case, while the same is not allowed for other design codes without going in to output file. Appreciate t...

ear Eng: I was Suggest if we can do the following - generate the drawings with the legend "Rxx" ? - Replace the current table shown in the snapshot with the section properties table attached the snap shot that can show the required

The Orientation Settings window provides the option "Use the center of the structure as the rotation center". However, when i perform the "Display Whole Structure" function, the rotation center is reset to 0,0,0. This happens when the Orientation ...

It would be helpful to add a measurement of angles function to the program especially when dealing with complicated angles and geometry it will help speed up the modeling process and aid in efficiency.

Design of foundation with shear link is not available in staad foundation advance (SFA). It is very necessary to implement the design of various foundation/s along with shear link design options also. Especially as per Indian standard codes.

When sorting information in a worksheet, you can rearrange the data to find values quickly. You can sort a range or table of data on one or more columns of data. you can sort load cases in display tables for both input and output data directly in ...

I often create models with multiple support conditions. Because of STAAD's requirements on support degrees of freedom I have to model lift cases first. This means that I cannot model seismic cases first as required if I want to use STAAD's seismic...